Dumble Fan Blades Replacement with 0.094” Round Bore, 6” Inch White RV Bathroom Fan Blade Replacement Camper Fan Blade

Say goodbye to smells and moisture and hello to clean air with the Dumble | 6-Inch White Round Bore RV Vent Fan Blade Replacement. It is compatible with any 12 Volt motor with a 0.094-inch round-shaped shaft. Not recommended if bore hole is larger than the motor shaft. If the bore hole is smaller than the shaft, carefully open the hole by slowly drilling out to fit the shaft in your motor. With no glue or installation hardware necessary, this blade fits directly on the rod (bore) that is attached to the armature by simply pushing onto the motor shaft. Make sure it is completely pushed up to prevent the blades from hitting vent over or other surroundings. It rotates counter-clockwise, but if that is the wrong direction for your fan, simply reverse the wires on the motor. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Product Features

  • GOODBYE MOISTURE & SMELLS: Use the Dumble | 6-Inch White RV Fan Blades Replacement with Round Bore 1-Pack to rid your RV or camper of lingering smells in the bathroom and built-up moisture
  • EASY TO INSTALL: Measure your fan shaft hole diameter and check to see if it is round or D-shaded bore (this replacement fan blade has a 2/25-inch / 2mm round bore); Determine the desired direction of airflow, carefully pull off the existing fan blades, apply a small amount of lubricant spray (or liquid soap) on the shaft and in the “hole” of the replacement fan blade, press the new replacement fan blade onto the motor shaft
  • COUNTER-CLOCKWISE ROTATION: This 6 inch fan blade rotates counter-clockwise; To determine the direction of spin on your existing fan, look down through the motor at the top of the blade; If these replacement fan blades rotate in the wrong direction, simply reverse the wires on the motor to change the direction the fan rotates
  • FITS YOUR RV: 6-inch (15.2cm) overall diameter (2-inch x 1.5-inch / 5.1cm x 3.8cm individual blades; 1.75-inch / 4.4cm diameter center bore plate); 2/25-inch (2mm) diameter center round bore hole that is compatible with Elixir, Heng’s, Jensen (pre-1995 range hood), and Ventline (pre-1995) roof vents and range hoods or any 12 Volt motor with a 0.094-inch round-shaped shaft; If bore hole is smaller than motor shaft, carefully open the hole by slowly drilling out to fit the shaft in your motor
  • BUILT TO LAST: Constructed from durable plastic for maximum longevity that resists rust and corrosion; White in color to match your existing fan cover